马鞍山附近想过夜电话联系

Hello, welcome to visit the great wall construction machinery concrete mixing station equipment price network!

Online consultation | About us | contact us | Website map
Hotline: 0371-65861528


Current location: home page > News Center > Special report >

How to determine that the failure of concrete mixing station is on the cylinder

Author: admin Release time: September 17, 2017 Number of visits:

As for the concrete mixing plant, it is inevitable that some problems will occur in the concrete mixing plant as a large part of the concrete mixing plant, which will affect the normal operation of some equipment Is it on the cylinder?
First of all, we need to observe whether there is oil leakage inside and outside the cylinder, because sometimes our installation is improper, resulting in eccentric installation of piston rod, resulting in cylinder oil leakage. In another case, there is insufficient supply of lubricating oil, wear or damage of sealing ring and sealing ring, and the latter is caused by impurities in the cylinder and scar of piston rod The cylinder leaks oil. If oil leakage is found, we must solve it in time to avoid the failure of the whole equipment caused by small reasons.
Secondly, observe whether there are two phenomena of insufficient output force and unstable action when the cylinder is working. It is no wonder that there are the following reasons for these two phenomena: first, the piston or piston rod is stuck; second, poor lubrication; third, insufficient air supply; fourth, there is condensate and impurities in the cylinder. If there are the following reasons, we must properly adjust the center position of the piston rod to repair.
The other is to observe the reliability of the oil atomizer; If the air supply pipeline is blocked, the condensate and impurities in the cylinder should be removed in time Later, the piston rod and cylinder head are damaged. The reason for this situation is that the piston rod is installed eccentric or the buffer mechanism does not work. The central position of the piston rod should be adjusted in time. If necessary, the buffer seal ring or adjusting screw should be replaced. In addition, if we find that the buffer effect of the air cylinder is poor, it is generally due to the wear of the buffer seal ring or the damage of the adjusting screw Sealing ring and adjusting screw.
Through the above several methods, you can roughly master some troubleshooting and determine whether the mixing station fault is caused by the cylinder. If there are some problems in our mixing station, we may as well find out the causes from the above aspects, so as to quickly repair the mixing station fault, and let our mixing station equipment quickly and normally put into production.